|
|
Post by thecrimsonchinh on Feb 13, 2016 3:21:13 GMT
I am having trouble getting the board to boot up correctly. I triple checked the wiring, the e3d fan and LED strip seems to be turning on when I turn the power on, but the board isn't flashing LEDs 1-4. The only light on the board that's lighting up seems to be D3. I am currently using the SD card that came from panucatt. Any ideas?
|
|
|
|
Post by codyb4175 on Feb 13, 2016 5:22:52 GMT
I too have the v2.0, when I turn on the power the supply does not come on. With nothing connected, it powers up fine and provides proper voltage(24v)
I also tried disconnecting all attached peripherals to make sure nothing was shorting anywhere but no change.
I wonder if these could be associated?
|
|
|
|
Post by thecrimsonchinh on Feb 13, 2016 15:53:20 GMT
I found out that I forgot to switch the wires on the endstop connectors. Now the four LEDs are turning on, and two of them are blinking. I got it to connect to the computer and everything installed, but the motors aren't responding. Including the extruder stepper.
|
|
|
|
Post by acetylcholine on Feb 13, 2016 16:16:54 GMT
I found out that I forgot to switch the wires on the endstop connectors. Now the four LEDs are turning on, and two of them are blinking. I got it to connect to the computer and everything installed, but the motors aren't responding. Including the extruder stepper. Are you using the supplied configuration files? Because I encountered the same issue, until I switched to the sample azteeg 2.0 file (Though, that still requires reconfiguring to the eclips3d settings). |
|
|
|
Post by thecrimsonchinh on Feb 13, 2016 16:24:42 GMT
Yeah, I'm using the supplied configuration files. It seems like when I turn the motors off, they power on. Then when I give the command to move, they power down and can be turned my hand, weird. Guess I'll try the azteeg 2.0 file. Do you think it will be possible for you to post the config file that works for you? I'm a little afraid of missing something going through these things, especially when changing so much.
|
|
|
|
Post by acetylcholine on Feb 13, 2016 16:43:31 GMT
Yeah, I'm using the supplied configuration files. It seems like when I turn the motors off, they power on. Then when I give the command to move, they power down and can be turned my hand, weird. Guess I'll try the azteeg 2.0 file. Do you think it will be possible for you to post the config file that works for you? I'm a little afraid of missing something going through these things, especially when changing so much. Be aware that this is NOT for coreXY, so you'll have diagonal movement as a result of X/Y axis commands. |
|
|
|
Post by thecrimsonchinh on Feb 13, 2016 17:25:06 GMT
I got the corexy movements going. Now I have to figure out why the Y and Z axis isn't homing. And why the extruder stepper doesn't seem to be responding. Whenever I try to extrude, all the other motors stop working.
Edit: Got everything working but the Y axis end stop. It'll hit the end stop and try to keep going. Using M119, it's saying that it's triggered. No idea what's going on.
|
|
