|
Post by jjlink on Oct 18, 2017 22:39:00 GMT
www.instructables.com/id/Eclips3D2-3D-Printer-Assembly-Guide/This step appears to be reversed: Step 37: Electronics Wiring 1 - Wiring to Printer Controller
Most parts are plugged directly into the Azteeg controller. See this guide
files.panucatt.com/datasheets/x5mini_wiring...
The only important things to note are that 1. the E3D cooling fan gets plugged into the fan slot closer to the mounting hole, with the red wire going in the Vin pin and the black going in the center SW pin. The dual cooling fan assembly goes in the other fan slot, again with the red wire going to the Vin pin and the black going to the SW pin.I tested and the pin set near the mounting hole are for the parts cooling fan; and the in-side set of pins are for the Hot-end cooling fan. Other than that one issue, the printer worked the first time. Impressive!
|
|
|
Post by 3DprintedLife on Oct 19, 2017 1:25:33 GMT
www.instructables.com/id/Eclips3D2-3D-Printer-Assembly-Guide/This step appears to be reversed: Step 37: Electronics Wiring 1 - Wiring to Printer Controller
Most parts are plugged directly into the Azteeg controller. See this guide
files.panucatt.com/datasheets/x5mini_wiring...
The only important things to note are that 1. the E3D cooling fan gets plugged into the fan slot closer to the mounting hole, with the red wire going in the Vin pin and the black going in the center SW pin. The dual cooling fan assembly goes in the other fan slot, again with the red wire going to the Vin pin and the black going to the SW pin.I tested and the pin set near the mounting hole are for the parts cooling fan; and the in-side set of pins are for the Hot-end cooling fan. Other than that one issue, the printer worked the first time. Impressive! Ah whoops I believe you are right, sorry about that! I'll make the correction.
|
|