Rick
Junior Member
Posts: 75
|
Post by Rick on Mar 7, 2016 0:22:17 GMT
My MK3 seems to be low in the middle when hot. Did anyone experience this and how did you fix it? I'm thinking of pulling it off and supporting the corners upside down and pressing on the middle. Any other suggestions on how to fix.
|
|
|
Post by theo1001 on Mar 8, 2016 15:59:27 GMT
I think mine is high in the middle. I clip window glass to the bed. Builtak stuck to the glass. It is very flat.
|
|
|
Post by rock75 on Mar 8, 2016 17:03:58 GMT
I think mine is high in the middle. I clip window glass to the bed. Builtak stuck to the glass. It is very flat. Any loss in heat doing this? Does it take longer for the build plate to heat up?
|
|
|
Post by theo1001 on Mar 8, 2016 19:47:31 GMT
I'm not sure about the heating time... I never printed direct. The first thing I did was adjust the power supply to max output. Made a huge difference in heating times.
|
|
Rick
Junior Member
Posts: 75
|
Post by Rick on Mar 8, 2016 20:59:33 GMT
I'm not sure about the heating time... I never printed direct. The first thing I did was adjust the power supply to max output. Made a huge difference in heating times. Did you just turn the voltage adjustment up, or did you make a change in the config.txt?
|
|
Rick
Junior Member
Posts: 75
|
Post by Rick on Mar 8, 2016 21:01:54 GMT
I think mine is high in the middle. I clip window glass to the bed. Builtak stuck to the glass. It is very flat. Did you have to make a spacer for the Y endstop?
|
|
|
Post by theo1001 on Mar 9, 2016 14:42:33 GMT
I just adjusted the power supplie to 14v. I think it is a big help in heating times.
I did not have to use a spacer for the end stop? Maybe post a photo?
|
|
|
Post by rock75 on Mar 19, 2016 3:47:16 GMT
So, my build plate was always a little "off" in the front right corner (a tad low there), but for the most part was quite flat. I just quickly learned to avoid the problem area. Recently I started having some first layer adhesion issues and was wondering if my Buildtak was just wearing out already??? I went ahead and replaced it and am still having significant problems. After much tinkering and trying to re-level it, it seems as if the aluminum plate is starting to warp. Anyone else having warping issues after a couple months of printing?
|
|