|
|
Post by codyb4175 on Jan 23, 2016 1:01:35 GMT
I am wanting to insulate the bottom of the heatbed. I was thinking of using ceramic batt insulation that is used for fire places since it will be in direct contact with high temperatures, but not really sure on how to apply / secure it.
What do you use or recommend?
|
|
|
|
Post by 3DprintedLife on Jan 23, 2016 18:00:16 GMT
Well there's a few options. Cheapest is probably cork, or you can go with some insulating tape (but don't just get the metal tape because that won't work in this case, you need the thick tape with insulation. Or you can get aerogel which I've heard works very well.
|
|
|
|
Post by librav on Jan 25, 2016 0:53:43 GMT
 I used 3/16" cork that I bought from Home Depot. Cut out a piece of polycarbonate 1/16" thick sheet to hold in place. Works great.
Note: Pic is upside down. |
|
|
|
Post by codyb4175 on Jan 25, 2016 3:10:51 GMT
Thanks guys, great ideas. I can't wait to start assembly.
|
|
|
|
Post by jjlink on Mar 2, 2016 16:27:36 GMT
This Aerogel Blanket Insulation is much more expensive ($30) however it has super insulating properties allowing high bed temperatures very quickly. I added it to my old 3D printer and it does an awesome job, plus it weighs almost nothing. bit.ly/AerogelBed This one is referenced in the how to article bit.ly/Spaceloft. This is what I purchased for my old printer bit.ly/AerogelTB. A great alternative to Spaceloft® or Cryogel® for dust-sensitive applications. |
|
|
|
Post by codyb4175 on Mar 4, 2016 0:55:47 GMT
I have some ceramic insulation for fireplaces from another project. How did you keep the aerogel in place?
|
|
|
|
Post by jjlink on Mar 4, 2016 2:37:29 GMT
I have some ceramic insulation for fireplaces from another project. How did you keep the aerogel in place? I used a High Temp Spray Adhesive. bit.ly/Hi-Temp |
|
