|
Post by theo1001 on Jan 10, 2016 5:42:11 GMT
I'm getting very close to printing. Yay. The instructions seem to peter out a bit at the end.
How do we mount the control board? Did we forget to put in the nuts for this in the instructions? Exactly where should it go?
How do we mount the power supply? Are there nuts for this in the instructions?
It sure looks good. Everything went together smoothly.
|
|
|
Post by 3DprintedLife on Jan 10, 2016 16:55:11 GMT
I'm getting very close to printing. Yay. The instructions seem to peter out a bit at the end. How do we mount the control board? Did we forget to put in the nuts for this in the instructions? Exactly where should it go? How do we mount the power supply? Are there nuts for this in the instructions? It sure looks good. Everything went together smoothly. Great I'm glad to hear your build went well! I know the end of the instructions are sparse, I had to focus on getting the important bits done and polished first. If you want to mount the control board you can print a part file which is included in the latest version STL kit on my website www.eclips3d.com/version-11.htmlPower supply does not have any mounting methods as of yet unfortunately!
|
|
|
Post by theo1001 on Jan 13, 2016 5:33:07 GMT
I'm working on a simple power supply mount and a controller mount. I would like easy access to the card slot... I'm also thinking of hanging the supply and controller outside so I can put on panels and heat up the build area. My M2 is contained and the heat is hard to manage. The wires get brittle and the controller runs hot. I will share if it works out.
Just the wiring left.
|
|
|
Post by theo1001 on Jan 15, 2016 20:26:13 GMT
It's Printing! I attached some picts. Attachments:
|
|
carlos
Junior Member
Posts: 94
|
Post by carlos on Jan 15, 2016 22:14:22 GMT
Sweet looking rig.
|
|
|
Post by rock75 on Jan 15, 2016 22:17:11 GMT
That looks great Theo! I really like how you have the controller and power supply mounted. Can you please share any .stl files for the brackets and controller box. Love the Red parts too btw!
Thanks!
Rock
|
|
|
Post by theo1001 on Jan 16, 2016 18:32:31 GMT
That looks great Theo! I really like how you have the controller and power supply mounted. Can you please share any .stl files for the brackets and controller box. Love the Red parts too btw! Thanks! Rock www.thingiverse.com/thing:1272907
|
|
|
Post by dkrockville on Jan 17, 2016 4:09:58 GMT
What are you using for a filament spool holder?
|
|
|
Post by theo1001 on Jan 17, 2016 5:49:05 GMT
I just got this spool holder working. Same as the 3Up setup I used. Works very well. Attachments:
|
|
|
Post by dkrockville on Jan 17, 2016 16:57:45 GMT
Thanks! Are those printed parts also on Thingiverse?
|
|
|
Post by theo1001 on Jan 18, 2016 3:32:51 GMT
Thanks! Are those printed parts also on Thingiverse? Not yet, had some sizing problems but if people are interested I could clean em up a bit.
|
|
|