|
Post by rock75 on Dec 27, 2015 5:42:01 GMT
On step 15: Adding Y Sliders it asks for 6x D3 bolts. My Kit only came with 3. See attached photo. Should Step 13 be asking for a different bolt? Seems like the right size but just making sure. If this is the right size I can just run to the store on Monday and grab a couple new bolts. Thanks!
|
|
carlos
Junior Member
Posts: 94
|
Post by carlos on Dec 28, 2015 4:38:38 GMT
I was meaning to write to andrew about that. But it's the same here too.
|
|
|
Post by 3DprintedLife on Dec 29, 2015 5:52:52 GMT
It appears you're right, these parts were changed around quite a bit and they must have gotten a bit mixed up with quantities for other parts. I actually believe two more of these will be needed for elsewhere in the printer so if you purchase extra parts on your own I would get a few extras. I will verify this tomorrow. Anyone who ordered a printer who needs these parts can use the contact form on the website to request the extra bolts be sent. Please use the same name and email used with the original purchase to help me find your order more easily. www.eclips3d.com/contact.html
|
|
|
Post by rock75 on Dec 29, 2015 14:06:45 GMT
It appears you're right, these parts were changed around quite a bit and they must have gotten a bit mixed up with quantities for other parts. I actually believe two more of these will be needed for elsewhere in the printer so if you purchase extra parts on your own I would get a few extras. I will verify this tomorrow. Anyone who ordered a printer who needs these parts can use the contact form on the website to request the extra bolts be sent. Please use the same name and email used with the original purchase to help me find your order more easily. www.eclips3d.com/contact.htmlThanks for the great service Andrew! I am headed to the bolt store later today. If I can't find a match then I will definitely hit you up for a replacement.
|
|