carlos
Junior Member
Posts: 94
|
Post by carlos on Dec 21, 2015 17:35:54 GMT
Can any one post a picture of the mainboard completely connected. I'd like that as a sanity check for what I have done. Reading is one thing, but a picture is much more. Thanks!
|
|
carlos
Junior Member
Posts: 94
|
Post by carlos on Dec 23, 2015 18:09:54 GMT
Well I gave it a go, kind of going in blind on this but so far this is what I have connected to the mainboard. Everything seems to be connected so far, except for the fan. I noticed it had 3 wires, but the connection to the main board is only 2. Would be great if anyone can help with a sanity check.
|
|
|
Post by 3DprintedLife on Dec 24, 2015 5:43:27 GMT
Everything looks good, and yes the fan does have 3 wires but you can just cut the yellow one off you don't need it for this printer. Then you can solder/crimp on the 1m length 2 pin cable to the fan, just make sure you have the positive and negatives right because it will only work if they are correct!
|
|