carlos
Junior Member
Posts: 94
|
Post by carlos on Dec 21, 2015 5:24:40 GMT
I've been following the build instructions. And have come to the final part of connecting all the wires to the power supply. Since the instructions are incomplete I'm a bit confused as to what should be connected to where. Is it possible to get a clear explanation? As far as I can tell the in switch connects to the power brick. And I'm thinking the red and black wires go straight from the mainboard. Using the pictures from the build instructions. Thanks for the help ahead of time.
|
|
carlos
Junior Member
Posts: 94
|
Post by carlos on Dec 23, 2015 18:11:59 GMT
This is what I have connected at this point. Again not sure if it's correct, but it seems to power up just fine. Would like some feedback incase I did connect something incorrectly.
|
|
|
Post by 3DprintedLife on Dec 24, 2015 5:45:13 GMT
That looks correct! Sorry for the instructions being incomplete this far in, I will be doing my best to complete the instructions by the end of the year!
|
|