|
Post by Jason Kaufmann on Oct 24, 2015 20:45:03 GMT
Hey,
So, I just finished building the printer, but I realized that there are no instructions for the x-endstop. Any instructions to give?
Thanks, Jason
|
|
|
Post by 3DprintedLife on Oct 24, 2015 22:24:02 GMT
Yeah sorry the instructions are taking so long, it takes a really long time to write everything out! The x endstop mounts on part A1 (the large x slider). It goes on that vertical plate on the same side as the motor, there are 2 cut outs and a hole. The endstop should fit in here, then you put an m3 bolt through the hole and on the other side you put the x gantry cable strain relief (or just a square nut if you dont want to use that). The endstop should line up with the y slider rod clamp with the protrusion that should be on the left side of the printer.
|
|