|
Post by 3DprintedLife on Jan 1, 2017 15:50:09 GMT
Hey Guys! So I know about 5 of you are up and printing, but I haven't heard from the rest of you. No need to post pictures or anything here, but if anyone still isn't done with their build or they're having trouble and they need something (parts, advice, etc.) please let me know! I'm here to help!
-Andrew
|
|
|
Post by dkrockville on Jan 1, 2017 17:45:35 GMT
Andrew I am wiring things up. Question on the z-lead screw -- z-axis all assembled. I found the plastic nut and spring but in your video you say that there are 2 nuts to compress the spring. Do you have a photo of this after installed? I think I am missing a nut. Thanks and Happy New Year 2017 to all the Eclips3d2 beta testers!
|
|
|
Post by dkrockville on Jan 1, 2017 17:50:08 GMT
The end stops cables have 2 wire connectors to the Azteeg. The board has 3 pins for each. How should these be installed?
|
|
|
Post by 3DprintedLife on Jan 1, 2017 18:27:20 GMT
Endstops connect to the signal and ground pins only, do not connect to the +5v pin! The z axis nut does have 3 parts total. The large metal cylinder with a small portion threaded, the sprint, then the small threaded black cap. The black cap will go in the top of the cylinder with the spring adding the tension. Hopefully this helps! -Andrew
|
|
|
Post by dkrockville on Jan 1, 2017 21:40:25 GMT
Endstops connect to the signal and ground pins only, do not connect to the +5v pin! The z axis nut does have 3 parts total. The large metal cylinder with a small portion threaded, the sprint, then the small threaded black cap. The black cap will go in the top of the cylinder with the spring adding the tension. Hopefully this helps! -Andrew Thanks for both answers.
|
|
|
Post by mgjones on Jan 2, 2017 20:58:34 GMT
I'm finishing up wiring today. The 24v heated bed has two red wires and a black insulated cable with two smaller gauge red and black wires in it. How should these be wired?
|
|
|
Post by 3DprintedLife on Jan 2, 2017 23:38:44 GMT
Nice! The two larger wires are power for the heated bed (wires will need to be extended through terminal block with the extra stripped wire segments) and the smaller ones connect to the short 2pin connector cable for the thermistor connection. Both of these wires should go through the 6 slot terminal block to connect/extend the wires.
|
|
|
Post by mgjones on Jan 3, 2017 1:30:02 GMT
Thanks. The heated bed is wired and working now.
|
|