Cable managment

[sveske]

I have been working on a system for cable managment, and would like comments..
The idea is roughly a channel that is clicked into the side of the profile.
I did print test, and need to make som modifications. 
in the bottom of my printer, there is an alu plate. then there will be a hole next to the profile, for cables to pass thru.
then half way up the profile, there will be a hole, to let the cables for the heated bed exit the cable channel. also holes for strapping cable with cableties.

further up, it will need to come around the motor and let the cables out!

Hope you get the idea. here is link to where I am now.. stil changing some things, but would apriciate ideas/thoughts.
designing is really new to me, so sorry for the rough look.

a360.co/2bTdXxu

I have also designed some feets, to lift it a little, since I am placing all electronics underneath
They have been printet with 0%infill in flex. works like a charm.


a360.co/2brbVUz

If it could interest anyone, I will put the files on Thingiverse tonight (EU time)

[carlos]

They are both great ideas. I've been using some other bouncy feet, made of hard PLA, but these look pretty good especially if made fro flexible filament.

[sveske]

Thanks. the feats works fine. they are printed at 0% infill.
that is why I made the 5 holes, to make sure they are strong enough.

the cable channel seems to work quite fine, I have printet and test mounted it (on my size printer) and is a perfekt fit.

Still need to get my alluminium bottom plate before I get to do all the wires.