|
|
Z Scar
May 10, 2016 19:07:11 GMT
Post by thecrimsonchinh on May 10, 2016 19:07:11 GMT
Does anyone have any optimal settings for the Eclips3d that minimizes Z scarring?
|
|
Rick
Junior Member
Posts: 75 
|
Z Scar
May 11, 2016 18:30:39 GMT
Post by Rick on May 11, 2016 18:30:39 GMT
Pictures?
|
|
|
|
Z Scar
May 11, 2016 18:55:07 GMT
Post by thecrimsonchinh on May 11, 2016 18:55:07 GMT
![]()   This is the best I have for now. I've changed the retraction settings from 0.5 to 4 with no noticeable changes. |
|
|
|
Z Scar
May 12, 2016 3:00:09 GMT
Post by 3DprintedLife on May 12, 2016 3:00:09 GMT
Try reducing your extrusion multiplier by about 10% and see if that helps. I'd change retraction back to 0.5, larger retraction can cause worse scarring. You can also try lowering the temperature and reducing perimeter print speed. Wipe will retract should help if you use cura or simplify3d
|
|
|
|
Z Scar
May 12, 2016 3:02:55 GMT
Post by thecrimsonchinh on May 12, 2016 3:02:55 GMT
I'll try the extrusion multiplier. I reduced my perimeter print speed as well as temperature before and it didn't fix it. Where's the wipe setting in cura?
|
|
|
|
Z Scar
May 12, 2016 15:38:05 GMT
Post by thecrimsonchinh on May 12, 2016 15:38:05 GMT
Just updating. The extrusion multiplier didn't solve the issue.
|
|
