|
Post by archit on May 9, 2016 18:21:22 GMT
I've just finished building the Eclips3D and am starting the configuration setup for the control board. Neither the Azteeg or the Smoothieboard were available when I bought the parts so I'm using the AZSMZ board and panel display. I know others have used this board and wondered if anyone has a config file setup which they would share.
|
|
|
Post by all3dprinting on Jun 2, 2016 0:51:18 GMT
config.txt (22.22 KB) See attached. This is the config file I use for my AZSMZ v2.1 controller with the eclips3d. You will of course need to calibrate your machine based on motors/drivers that you have. This config file is setup with the XYZ using the DRV8825 drivers, and the extruder using a A4988 driver. if you use all DRV8825 you will need to change your extruder steps.
|
|