Rick
Junior Member
Posts: 75
|
Post by Rick on Mar 19, 2016 18:33:07 GMT
I remade these rod holders so that they can be printed laying flat. Mine are cracking along the layer lines since the part was originally printed vertically. Click for bigger: I copied Andrews original design and split the top and bottom apart so you can print them large flat sides down. I haven't tested them yet as mine are still holding together. But, I suspect that they will fail sooner or later. Anyway they are up on Thingiverse, let me know if you use them and how they work for you. www.thingiverse.com/thing:1428191
|
|
carlos
Junior Member
Posts: 94
|
Post by carlos on Mar 19, 2016 19:06:50 GMT
The same thing has sort of happened with mine, PETG is much more forgiving. So it's more of a stretch as opposed to splitting. Will keep these handy when the time comes.
|
|
|
Post by scottadams on Mar 20, 2016 6:32:29 GMT
Great idea, Rick. I think I'll have to print these out just in case. I've been lucky and haven't had any splitting. PETG seems like a filament choice too.
|
|