Rick
Junior Member
Posts: 75
|
Post by Rick on Mar 3, 2016 21:11:24 GMT
You specify to use D10 bolts to hold down these G19 brackets, but they are not long enough to make it to the T-nuts? It looks like the D11 bolts will reach should I use those?
Rick
|
|
|
Post by 3DprintedLife on Mar 4, 2016 1:18:01 GMT
You specify to use D10 bolts to hold down these G19 brackets, but they are not long enough to make it to the T-nuts? It looks like the D11 bolts will reach should I use those? Rick Sure if they fit! D10 should fit but depending on exactly which T-Nuts you use and the SK10 shaft supports, the gap may be larger. Use whatever bolts fit and if necessary, you can use washers as spacers on the bolt if you only have bolts that are too long or too short.
|
|
Rick
Junior Member
Posts: 75
|
Post by Rick on Mar 4, 2016 2:53:29 GMT
There was not enough D10 anyway....
But, I used all of the parts in you specified in the BOM. I measured the base of the G19 it is 5.2 mm thick so a 8mm bolt has no chance of working
|
|