|
Post by michaelkittrell on Dec 10, 2015 19:16:56 GMT
Any suggestions for makerbot desktop printer settings?
I am planning on using quick custom settings
.2mm with 50% infill Raft on, support on extruder temp 230c
but I don't know what to set for the "Number of shells"? Currently 2, I was thinking of setting it to 10 but this starts to look a lot like 100% infill judging by the grams of filament used.
Any other settings I should modify?
thanks in advance,
michael
|
|
carlos
Junior Member
Posts: 94
|
Post by carlos on Dec 17, 2015 17:48:11 GMT
2 to 3 shells should suffice. and the other setting should be a o k.
|
|
|
Post by michaelkittrell on Jan 26, 2016 18:50:05 GMT
I just got my parts back from the university. I did end up using 3 shells and they look fine. No idea how they will perform, but probably adequately.
|
|