|
Post by alexsfa on Apr 20, 2017 9:21:53 GMT
Hi 3DprintedLife, have news to share with us about Eclips3D2 version 2.1
Thanks and best regards
Alessandro
|
|
|
Post by 3DprintedLife on Apr 20, 2017 22:29:59 GMT
Patience is all I can say unfortunately!...
Just kidding! Progress is being done, although it is slow going. I'm hoping to finalize version 2.1 by the end of June and around that time I will be looking into reopening sales. I'm planning on selling in a similar style to V1.1, where I just sell the custom bits and the customers purchase their own parts from just a few major retailers (most likely misumi, mcmaster-carr, and robotdigg).
Upgrades from V2 include -Better cooling with dual fans, one on each side -Easier extruder carriage assembly -Slightly simplified machined parts -Last but not least, cost reductions! Hopefully below $1100 for the entire printer! Without sacrificing quality of course!
|
|