sveske
New Member
Decided next 3d printer build :-)
Posts: 45
|
Post by sveske on Aug 24, 2016 10:23:33 GMT
FINALLY my printer is build. working on cable management and enclosure now.
My printer is build with the plan of using a Ramps 1.4 Have anyone else done this? reason for Ramps, is that I have a complete set!
Reason for asking, is to get fingers on a working setup file, if not, I will just have to make one my self .-)
|
|
|
Post by animoose on Aug 24, 2016 19:47:50 GMT
I used RAMPS before switching to the Azteeg X5. I have attached my configuration.h, based on Marlin 1.0.2-1. Attachments:Configuration.h (37.01 KB)
|
|
sveske
New Member
Decided next 3d printer build :-)
Posts: 45
|
Post by sveske on Aug 25, 2016 6:30:15 GMT
Thanks, when you changed, was it an improvement? or for some other reason?
Jesper
|
|
|
Post by animoose on Aug 25, 2016 15:31:26 GMT
I started with the RAMPS as the Azteeg was out of stock at the time. It has definitely been an improvement: the motion is smoother and quieter.
|
|
sveske
New Member
Decided next 3d printer build :-)
Posts: 45
|
Post by sveske on Aug 26, 2016 7:30:34 GMT
Hmm.. so what you are saying, is the printer works better on the azteeg?
Now I start to regret saving the money lol
|
|