|
Wiring
Oct 8, 2015 0:44:21 GMT
via mobile
Post by Chris Rice on Oct 8, 2015 0:44:21 GMT
Hello,
I read the other thread about the wiring but there didnt seem to be an answer. If i wanted to get the wiring myself, not from the Eclips3d store, does anyone know of any links or places where I can buy them. It's just 14 and 18 gauge wire right? Also, what type of crimp connectors would i need in order to plug them into the azteeg board or connect it to the power supply? Any help would be greatly appreciated.
Chris
|
|
|
Wiring
Oct 8, 2015 2:55:59 GMT
Post by 3DprintedLife on Oct 8, 2015 2:55:59 GMT
Just standard 14 and 18 gauge wire, yes. Just make sure it is really this gauge, some wire companies skimp and mislabel wire to save money. For the crimp connectors, you will need blue #4-40 forks, red #4-40 forks, and red .250" insulated female spades. I'll be putting these in v1.1 of the bom when that is released but feel free to post links here if you want me to check to make sure the parts are good before you buy!
|
|