|
Post by animoose on Jul 2, 2016 6:06:50 GMT
I've seen two different versions of the "enable" lines in the config. The official Azteeg V2 and V3 configs from the Smoothieware site have: alpha_en_pin 0.10 # Pin for alpha enable pin and similar for beta and gamma. But the one on the Eclips3D site and also a V2 config posted on eclips3d.proboards.com/thread/116/azteeg-v2-config-txt have" alpha_en_pin 0.10! # Pin for alpha enable pin which is the inverted version. Which is correct? Does it matter?
|
|
|
Post by scottadams on Jul 4, 2016 4:24:55 GMT
I'm sure the inversion does matter and likely just reverses the enable. On my V2 it shows 0.10! and works for me. It seems that the worst that would happen would be you have it the wrong way around and they won't move. Just invert them and you should be good.
|
|
|
Post by animoose on Jul 5, 2016 0:18:45 GMT
As a quick follow up, for the record, my board requires that the ! marks are NOT present. The motors don't run if they are. This could be differences between the V2 and V3 boards, or it might be because of the specific steppers: I am using the new SD5984 stepper drivers, instead of the SD8825s.
|
|