|
Post by scottadams on May 15, 2016 22:07:25 GMT
I'm trying to find the ends that attach to the steppers in the BOM and the end stop connectors so I can create my own custom wiring to clean up the look of my Eclips3D. Anyone have an idea of their exact model(s) or specs so I can source them. I would need the housing and the pins. I'm pretty sure Digikey would have them since I see something that looks pretty similar. They'd be easy for me to buy from since I'm in the USA and have bought from them before. Thanks for any help you can give.
|
|
|
Post by 3DprintedLife on May 16, 2016 2:43:55 GMT
used to know but I completely forget, sorry. I know digikey has them for sure, perhaps someone else would be able to help. JST sounds familiar but I can't say anything for sure!
|
|
|
Post by scottadams on May 19, 2016 17:24:28 GMT
I think I may have found them! Went to OpenBuilds to see if they had specs on the steppers. They did for the female side, and DigiKey helped me find the mating male side I need. And the crimp connectors to go inside. I still can't verify the connectors on the end stops, but I think they're the same series - just with 4 instead of 6 conductors. So, they seem to be JST PHR series. PHR-6 and PHR-4. I believe the crimp pins that go to the housing are SPH-002T-P0.5S. I think I'll go ahead and order them and see if they work. I'll report my findings here.
|
|
|
Post by 3DprintedLife on May 20, 2016 2:52:32 GMT
Yeah that sounds familiar! Let us know how they work! -Andrew
|
|