|
Post by librav on Feb 13, 2016 21:44:04 GMT
Hi Andrew,
Will the Firmware you have listed in the Eclips3d v1.1 Firmware directory work with the X5 V2.0 controller board? Mine boots ok, leds blink, but no motor response with either repetier or pronterface. Would you kindly provide a firmware directory we can download onto the X5 V2.0 SD card? Sorry to make such a request, I know your busy. I just don't know how to correct this no motor response problem.
Thanks !!!
|
|
|
Post by wasabi on Feb 14, 2016 18:16:30 GMT
The the config.txt I posted in 'General Discussion'. I was having these exact same symptoms trying to use the 1.1 config.
|
|