|
Post by travistrue on Feb 9, 2016 7:13:57 GMT
As stated in the instructions, and the X5 Mini datasheet, the pins' order is 5v-SIG-GND. The endstops are wired in a different order, though. Should I cut, and reorder the wires for all 3 endstops? This appears to be what needs to happen, but I want to check before I do anything unnecessary.
|
|
|
Post by wasabi on Feb 9, 2016 16:45:38 GMT
Yes. There is a post here about it somewhere. Also, Andrew mentions it in the quick start guide --> Link
|
|
|
Post by 3DprintedLife on Feb 9, 2016 23:33:06 GMT
You don't have to cut them, the wire pins can be removed from the plastic shroud by simply using a pin (or your fingernail) to lift a little plastic tab, then you can reorder them in the proper order.
|
|
|
Post by travistrue on Feb 10, 2016 2:00:39 GMT
Ok, I'll get to reordering them.
|
|
|
Post by LibraJ on Feb 11, 2016 14:55:36 GMT
I think Andrew meant reinsert and not reorder the wires.
|
|