|
Post by travistrue on Feb 9, 2016 6:32:57 GMT
The fan duct I printed (A8) isn't long enough for its screw to reach the X-slider gantry's screw hole. It's about 1.5mm short of reaching it. I'm considering on sanding down the spot where the fan duct clips on at the bottom of the gantry in an effort to get it to reach. I've got the fan portion built with the fan installed, and everything seems to fit pretty well. The fan duct seems to fit in place thanks to the friction due to how it clips at the bottom, being connected to the fan up top, and being rubbed up between the belts that are clipped on.
|
|
Rick
Junior Member
Posts: 75
|
Post by Rick on Feb 9, 2016 19:06:52 GMT
There is a new A8 part in the 1.1 STL archive that fits better. dated 2/8/16
Rick
|
|
|
Post by travistrue on Feb 10, 2016 1:58:39 GMT
Alright, I'll download it.
|
|